Description
Features:
- Dimensions: 53mm x 21mm x 13mm
- Wire Length: 50 mm
- Battery Compatibility: 17 V (NiMH 8.4V-14,4V, LiPo 7.4V-14.8V, LiFe 9.9V-13.2V)
- Compatibility: Designed for all AEG gearboxes
- Professional made MOSFET with active braking for AEG airsoft rifles
- Very small device dimensions - designed to fit nearly anywhere
- Pre-soldered wires allow for faster and easier installation
- Wiring and accessories are included if you're not familiar with soldering circuit boards
- Board covered by conformal coating, it protect device against water
- Designed for M170 springs and above
- Made to increase an AEG's rate of fire, trigger response and battery efficiency
- Active braking uses the excess energy from the motor to stop it and prevent over spinning
- Boosts AEG's rate of fire and improves battery efficiency
- Voltage stabilization to reduce heat when in use
- No current consumption in the idle mode
- No sparking on switch contacts
- A functional gearbox cut off lever, selector plate, reverse latch, trigger and trigger block is needed for proper use
Package Includes:
- JAG Arms Extreme Active Braking MOSFET
- Wire set & connectors